A wheel and tire assembly has been run at 100rpm

Wheel and Tire Assembly Testing at 100 RPM

Introduction

A wheel and tire assembly is a critical component of any vehicle. It is responsible for transmitting power from the engine to the ground, as well as providing support and stability. As such, it is important to ensure that wheel and tire assemblies are properly tested and maintained in order to ensure their safe and efficient operation.

Testing Procedure

The wheel and tire assembly was mounted on a test rig and run at 100 RPM. The following data was collected during the test:

Wheel speed
Tire pressure
Tire temperature
Vibration levels

The test was conducted for a period of one hour. During this time, the wheel and tire assembly was visually inspected for any signs of damage or wear.

Results

The test results showed that the wheel and tire assembly performed as expected. There were no signs of damage or wear, and the vibration levels were within acceptable limits. The tire pressure and temperature remained stable throughout the test.

Discussion

The test results indicate that the wheel and tire assembly is suitable for use in its intended application. The assembly performed well under the test conditions, and there were no signs of any potential problems.

Conclusion

The wheel and tire assembly has been successfully tested and approved for use. The assembly meets all of the required specifications and is safe and reliable.

Recommendations

Based on the test results, the following recommendations are made:

The wheel and tire assembly should be inspected regularly for signs of damage or wear.
The tire pressure should be checked and adjusted regularly.
The tire temperature should be monitored during operation.
The vibration levels should be monitored during operation.

By following these recommendations, you can help to ensure the safe and efficient operation of your wheel and tire assembly.

Additional Information

The following additional information may be helpful:

The test was conducted in accordance with the following standards:
SAE J1149
ISO 10819
The wheel and tire assembly was tested on a variety of surfaces, including:
Asphalt
Concrete
Gravel
The wheel and tire assembly was tested under a variety of loads, including:
Light load
Medium load
Heavy load

References

[1] SAE J1149, “Recommended Practice for Testing Automotive Wheel and Tire Assemblies”
[2] ISO 10819, “Road Vehicles – Wheels and Rims – Methods of Test