How to fit wide wheels and tires on a c10

## How to Fit Wide Wheels and Tires on a C10

Fitting wide wheels and tires on a C10 requires careful planning and execution. By following the steps outlined below, you can ensure a proper fit and avoid any potential problems.

### Step 1: Determine the Right Wheel and Tire Size

The first step is to determine the right wheel and tire size for your C10. You will need to consider the following factors:

The width of your axle: The width of your axle will determine the maximum width of the wheels you can fit.
The diameter of your tires: The diameter of your tires will determine how much clearance you have between the tires and the fenders.
The offset of your wheels: The offset of your wheels will determine how far the wheels will extend past the fenders.

It is important to note that not all wheel and tire combinations will fit on a C10 without modifications. You may need to make some modifications to the suspension or fenders in order to fit the wheels and tires you want.

### Step 2: Gather the Necessary Tools and Materials

Once you have determined the right wheel and tire size, you will need to gather the necessary tools and materials. These include:

A jack and jack stands: You will need a jack to lift the C10 and jack stands to support it while you work.
A socket wrench: You will need a socket wrench to remove the lug nuts and wheels.
A torque wrench: You will need a torque wrench to tighten the lug nuts to the proper torque.
A tape measure: You will need a tape measure to measure the width of the axle, the diameter of the tires, and the offset of the wheels.
A set of new lug nuts: You will need a set of new lug nuts to secure the wheels.

### Step 3: Remove the Stock Wheels and Tires

The next step is to remove the stock wheels and tires. To do this, follow these steps:

1. Place the C10 on jack stands.
2. Remove the lug nuts from the wheels.
3. Pull the wheels straight off the axle.
4. Remove the tires from the wheels.

### Step 4: Mount the New Wheels and Tires

Once you have removed the stock wheels and tires, you can mount the new wheels and tires. To do this, follow these steps:

1. Place the new tires on the wheels.
2. Mount the wheels on the axle.
3. Tighten the lug nuts to the proper torque.

### Step 5: Check the Fitment

Once you have mounted the new wheels and tires, you need to check the fitment. To do this, follow these steps:

1. Lower the C10 to the ground.
2. Check the clearance between the tires and the fenders.
3. Check the offset of the wheels.
4. Make any necessary adjustments to the suspension or fenders.

### Tips for Fitting Wide Wheels and Tires on a C10

Here are a few tips for fitting wide wheels and tires on a C10:

Use a spacer kit: A spacer kit can be used to widen the axle, which will allow you to fit wider wheels and tires.
Roll the fenders: Rolling the fenders involves using a fender roller to widen the fenders, which will give you more clearance for the tires.
Install a lift kit: A lift kit can be used to raise the C10, which will give you more clearance for the wheels and tires.

### Conclusion

Fitting wide wheels and tires on a C10 can be a challenging task, but it is possible with the right planning and execution. By following the steps outlined above, you can ensure a proper fit and avoid any potential problems.