How to remove wheel and tire from e60 m5

## How to Remove Wheel and Tire from E60 M5

### Tools and Materials

– Jack and jack stands
– Lug wrench
– Wheel chocks
– Gloves (optional)

### Safety Precautions

1. Park the vehicle on a level and stable surface.
2. Engage the parking brake.
3. Place wheel chocks behind the wheels opposite the one you will be removing.
4. Allow the engine to cool before lifting the vehicle.
5. Wear gloves to protect your hands from dirt and grease.

### Step-by-Step Instructions

#### 1. Loosen Lug Nuts

– Use the lug wrench to loosen the lug nuts on the wheel you will be removing, but do not remove them completely.
– Turn the lug nuts counterclockwise to loosen them.

#### 2. Lift the Vehicle

– Position the jack at the designated jack point closest to the wheel you will be removing. Refer to your vehicle’s owner’s manual for the correct jack points.
– Slowly pump the jack to raise the vehicle until there is approximately 6 inches of clearance between the ground and the tire.

#### 3. Place Jack Stands

– Place jack stands under the designated jack points on either side of the wheel you will be removing.
– Lower the vehicle onto the jack stands to provide additional support.

#### 4. Remove Lug Nuts and Wheel

– Completely remove the lug nuts by hand or using the lug wrench.
– Carefully lift the wheel off the hub and set it aside.

#### 5. Inspect Brake Components

– While the wheel is off, take the opportunity to inspect the brake components, such as the brake pads, rotors, and calipers.
– Look for any signs of wear or damage that may require attention.

#### 6. Reinstall Wheel and Tire

– Align the wheel with the hub and carefully lift it into place.
– Screw the lug nuts onto the wheel by hand.
– Tighten the lug nuts using the lug wrench, but do not overtighten.
– Lower the vehicle from the jack stands.
– Fully tighten the lug nuts using the lug wrench.

#### 7. Check Lug Nut Torque

– Using a torque wrench, tighten the lug nuts to the specified torque for your vehicle. Refer to your vehicle’s owner’s manual for the correct torque specifications.
– Check the lug nut torque after driving a few miles to ensure they are still properly tightened.

### Tips

– If the lug nuts are seized, use a penetrating oil to help loosen them.
– Be careful not to overtighten the lug nuts, as this can damage the threads.
– If you encounter any difficulties or uncertainties, consult your vehicle’s owner’s manual or a qualified mechanic.

### Troubleshooting

– Loose Lug Nuts: Check the lug nut torque and tighten as necessary.
– Difficulty Removing Wheel: Use a penetrating oil on the hub and tap around the wheel with a rubber mallet to help loosen it.
– Damaged Brake Components: Contact a qualified mechanic for diagnosis and repair.